Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Ford Transit Connect TitaniumFACTORY OEM SERVICE PROCEDURE
Section 92 (Interior Lighting System)
WARNING: This page is about a different car, the 2016 Ford Transit Connect. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Diagnosis And Testing
- Interior Lighting
- Notes
- DTC Chart: Body Control Module (BCM)
- Symptom Chart: Interior Lighting
- Pinpoint Tests
- Pinpoint Test A : The Courtesy Lamps Do Not Illuminate With A Door Open
- Pinpoint Test B : One Or More Interior Courtesy Lamps Are Inoperative
- Pinpoint Test C : All The Courtesy Lamps Stay On Continuously
- Pinpoint Test D : One Or More Demand Lamps Are Inoperative
- Pinpoint Test E : The Battery Saver Does Not Deactivate After Timeout
- Pinpoint Test F : The Courtesy Lamps Do Not Illuminate With The Liftgate Or Rear Doors Open
- Interior Lighting
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.