Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Ford Transit Connect TitaniumFACTORY OEM SERVICE PROCEDURE
Key Programming Using Diagnostic Equipment
For information on Ford Color Coded Illustrations refer to OEM Color Coding .
Programming
NOTE:
If 8 keys are already programmed, this procedure does not allow any more PATS keys to be programmed without erasing all stored key codes first.
- Insert the unprogrammed PATS key into the ignition lock cylinder and turn the ignition lock cylinder to RUN.
- From the diagnostic scan tool, enter TOOLBOX. Select Body>Security>PATS Functions and follow the on-screen instructions to enter the PATS security access.
- From the diagnostic scan tool menu select "Program additional ignition key" and follow the on-screen instructions.
- The engine should now start with the new PATS key.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.