The chart describes specific module configuration information:

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Progammable Parameters
APIM (without touchscreen)	7D0	Yes	Yes	No	None
APIM (with touchscreen)	7D0	Yes	Yes	No	Tire size Travel Link
ABS module	760	Yes	Yes	IVD initialization	Line Lock feature enabled
ACM	727	Yes	Yes	No	None
BCM	726	Yes	Yes	Ambient lighting calibration Rear view camera calibration	Auto unlock enable/disable Trim switch inhibit enable/disable DRL configuration Remote start enable Remote start lighting enable TracKey configuration
BCMB	7B7	Yes	Yes	No	Entry lighting Blue Red Green
CCM	764	Yes	Yes	Radar horizontal and vertical alignment calibration	None
DSP	783	Yes	Yes	No	None
DACMC (integrated with ACM)	7D5	Yes	Yes	No	None
DDM	740	Yes	Yes	Windows initialization	None
DSM	744	Yes	Yes	No	None
SCME	776	Yes	Yes	No	None
FCIM	7A7	Yes	Yes	No	None
FCDIM	7A5	Yes	Yes	No	None
GWM	716	Yes	Yes	No	None
GPSM	701	Yes	Yes	No	None
HUD module	7B2	No	No	No	None
ICM	784	Yes	Yes	No	None
IPC	720	Yes	Yes	No	AEIS with override Autolock control function Auto unlock control function DRL control function Driver Beltminder Passenger Beltminder Rear differential temperature configuration Remote start Climate settings Driver seat Passenger seat Rear defrost Line lock feature enabled TracKey configuration
Moveable Roof Control Module A (MRCMA)	790	No	No	No	None
Moveable Roof Control Module B (MRCMB)	7B0	No	No	No	None
OCSM	765	No	No	OCSM re-zero	None
PAM (integrated with BCM)	736	Yes	Yes	No	None
PSCM	730	Yes	Yes	No	None
PCM	7E0	Yes	Yes	Misfire Monitor Neutral Profile Correction procedure	None
PDM	741	Yes	Yes	Windows initialization	None
RTM	751	Yes	Yes	No	None
RCM	737	Yes	Yes	No	Driver Beltminder enable/disable Passenger Beltminder enable/disable
SODL	7C4	Yes	Yes	No	BLIS/CTA enable/disable Blockage enabled
SODR	7C6	Yes	Yes	No	BLIS/CTA enable/disable Blockage enabled
SCCM	724	Yes	Yes	No	Courtesy wipe enable/disable
VDM	721	No	No	Suspension height sensor calibration	None

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Module Configuration and Parameter Chart

Use the Manual With the Right Hardware

When to See a Mechanic