2017 Ford GTFACTORY OEM SERVICE PROCEDURE

Wipers And Washers System DTCS: SCCM

DTC Description Action
B1008:09 Wiper Mode Switch: Component Failure GO to Pinpoint Test I
B1051:09 Front Washer Switch: Component Failure GO to Pinpoint Test J
B1131:02 Wiper motor module: General Signal Failure If the wipers are inoperative, or no symptom is present, GO to Pinpoint Test A
If the wipers are always on, GO to Pinpoint Test D
B1131:08 Wiper motor module: Bus Signal / Message Failure GO to Pinpoint Test B
B1131:11 Wiper motor module: Circuit Short To Ground GO to Pinpoint Test B
B1131:49 Wiper motor module: Internal Electronic Failure GO to Pinpoint Test K
B1131:55 Wiper motor module: Not Configured CARRY OUT the PMI for the SCCM using As-Built data.
B1131:9A Wiper motor module: Component or System Operating Conditions DIAGNOSE the symptom present with the wiper system. REFER to Symptom Chart: Wiper and Washer .
All other Diagnostic Trouble Codes (DTCs) - REFER to: Steering Wheel and Column Electrical Components .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.