Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Ford GTFACTORY OEM SERVICE PROCEDURE
Transmission Cooling System DTCS
| DTC | Description | Action |
|---|---|---|
| P0218 | Transmission Fluid Temperature Sensor "A" Over Temperature Condition | If any TFT sensor circuit diagnostic trouble codes (DTCs) are present, RESOLVE those first. Otherwise, CLEAR the DTC and road test the vehicle. If DTC P0218 returns, REFER to Symptom Chart - Transmission Cooling . |
| P0480 | Fan 1 Control Circuit (Engine oil cooler fan) | GO to Pinpoint Test A |
| P0481 | Fan 2 Control Circuit (Clutch fluid cooler fan) | GO to Pinpoint Test A |
| P0691 | Fan 1 Control Circuit Low (Engine oil cooler fan) | GO to Pinpoint Test A |
| P0692 | Fan 1 Control Circuit High (Engine oil cooler fan) | GO to Pinpoint Test A |
| P0694 | Fan 2 Control Circuit Low (Clutch fluid cooler fan) | GO to Pinpoint Test A |
| P0695 | Fan 2 Control Circuit High (Clutch fluid cooler fan) | GO to Pinpoint Test A |
| P0696 | Fan 3 Control Circuit High (Gearset fluid cooler fan) | GO to Pinpoint Test A |
| P2787 | Clutch 'A' Temperature Too High | ALLOW the vehicle to cool, CHECK the clutch fluid level and correct as necessary, if the condition still exists, REFER to Symptom Chart - Transmission Cooling . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.