Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Ford GTFACTORY OEM SERVICE PROCEDURE
Supplemental Restraint System DTCS: BECMB
| DTC | Description | Action |
|---|---|---|
| B00A0:11 | Occupant Classification System: Circuit Short To Ground | REFER to: Pinpoint Test - DTC: AQ . |
| B00A0:12 | Occupant Classification System: Circuit Short To Battery | REFER to: Pinpoint Test - DTC: AQ . |
| B1123:11 | Restraints Ignition Relay: Circuit Open | REFER to: Pinpoint Test - DTC: AQ . |
| B1123:12 | Restraints Ignition Relay: Circuit Short To Battery | REFER to: Pinpoint Test - DTC: AQ . |
| B1142:62 | Ignition Status 1: Signal Compare Failure | REFER to: Pinpoint Test - DTC: AR . |
| B11D9:13 | Vehicle Battery: Circuit Open | REFER to: Pinpoint Test - DTC: AR . |
| B13BF:14 | Run/Start Input: Circuit Short to Ground or Open | REFER to: Pinpoint Test - DTC: AR . |
| U0100:87 | Lost Communication with ECM/PCM A: Missing Message | REFER to: Pinpoint Test - DTC: AS . |
| U0140:87 | Lost Communication with Body Control Module: Missing Message | REFER to: Pinpoint Test - DTC: AT . |
| U1000:00 | Solid State Driver Protection Active -Driver Disabled | DIAGNOSE any other BECMB Diagnostic Trouble Codes (DTCs) first. CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. If DTC U1000:00 returns, INSTALL a new BECMB. REFER to: Battery Energy Control Module B (BECMB) . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | CHECK vehicle history for recent service actions related to this module. This DTC sets due to incomplete or improper PMI procedures. If there have been recent service actions with this module, REPEAT the PMI procedure as directed by the diagnostic scan tool using As-Built data. |
| U3000:49 | Control Module: Internal Electronic Failure | INSTALL a new BECMB. REFER to: Battery Energy Control Module B (BECMB) . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.