2017 Ford GTFACTORY OEM SERVICE PROCEDURE

DTC Chart: Steering Column Control Module (SCCM)

DTC Description Action
C1B00:09 Steering Angle Sensor: Component Failure This DTC sets if the steering wheel rotation sensor has an internal failure.
INSTALL a new steering wheel rotation sensor. REFER to: Steering Angle Sensor Module (SASM) .
C1B00:29 Steering Angle Sensor: Signal Invalid This DTC sets if the SCCM receives invalid information from the steering wheel rotation sensor.
REMOVE the steering wheel rotation sensor. INSPECT the connector terminals for bent pins, pushed-out pins, spread terminals and foreign material. REPAIR as necessary.
If the connector terminals are OK, INSTALL a new steering wheel rotation sensor. REFER to: Steering Angle Sensor Module (SASM) .
-- Other SCCM Diagnostic Trouble Codes (DTCs) REFER to: Steering Wheel and Column Electrical Components .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.