Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Ford GTFACTORY OEM SERVICE PROCEDURE
Electronic Engine Controls - Component Location
Electronic Engine Controls- Front
| Item | Description |
|---|---|
| 1 | PCM |
| 2 | Right hand VCT oil control solenoids |
| 3 | Turbocharger boost pressure/Charge air cooler temperature sensor |
| 4 | Crankcase Pressure Sensor |
| 5 | Left hand VCT oil control solenoids |
| 6 | FRP temperature sensor |
| 7 | FRP sensor |
| 8 | Left hand TC bypass valve |
| 9 | Left hand MAFT sensor |
| 10 | EOP sensor |
| 11 | Turbocharger inlet pressure sensor |
| 12 | Right hand MAFT sensor |
| 13 | Right hand TC bypass valve |
Electronic Engine Controls - Rear
| Item | Description |
|---|---|
| 1 | Left hand CMP sensors |
| 2 | MAPT sensor |
| 3 | Right hand CMP sensor |
| 4 | KS sensor |
| 5 | CHT sensor |
| 6 | CKP sensor |
| 7 | HO2S |
| 8 | Catalyst monitor sensors |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.