Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Ford Escape SFACTORY OEM SERVICE PROCEDURE
Body Control Module (BCM)
| DTC | Description | Action |
|---|---|---|
| B112B:07 | Steering Wheel Module: Mechanical Failure | GO to Pinpoint Test A |
| B112B:83 | Steering Wheel Module: Value of Signal Protection Calculation Incorrect | GO to Pinpoint Test A |
| B112B:87 | Steering Wheel Module: Missing Message | GO to Pinpoint Test A |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: Body Control Module (BCM) . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.