Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Ford C-Max Energi TitaniumFACTORY OEM SERVICE PROCEDURE
Component Locations
Select a section or procedure below to view factory instructions:
Automatic Transmission - Hf35Automatic Transmission Cooling SystemAutomatic Transmission External ControlsAuxiliary Climate Control SystemBody Panel System - Body ClosuresClimate Control System - General InformationComponent Harness Location ViewsEngine - 2.0L DURATEC - Hybrid (96KW/130PS)Engine Controls - Fuel Charging And Controls - 2.0L DURATEC - Hybrid (96KW/130PS)Engine Cooling System - 2.0L DURATEC - Hybrid (96KW/130PS)Engine Emission Control System - 2.0L DURATEC - Hybrid (96KW/130PS)Engine Ignition System - 2.0L DURATEC - Hybrid (96KW/130PS)High Voltage Battery Charging SystemHigh Voltage Charging System (High Voltage Battery, Mounting, And Cables)Horn SystemInformation And Entertainment System - General Information - Vehicles With: Am Fm Cd SyncInformation And Entertainment System - General Information - Vehicles With: Am Fm Cd Sync Touchscreen DisplayMULTIFUNCTION Electronic ModulesOEM Component Harness Location ChartsParking Aid SystemParking Aid System - Vehicles With: Active Park AssistPassive Anti-Theft System (Pats) - Vehicles With: Push Button StartSide And Rear Vision SystemSupplemental Restraint SystemTire Pressure Monitoring System (TPMS)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.