Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Ford C-Max Energi TitaniumFACTORY OEM SERVICE PROCEDURE
RFA Module
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B10AB:00 | Remote Keyless Entry Synchronization: No Sub Type Information | GO to Pinpoint Test R |
| B10C1:24 | Left Front Unlock Pull Switch: Signal Stuck High | GO to Pinpoint Test W |
| B10C3:24 | Right Front Unlock Pull Switch: Signal Stuck High | GO to Pinpoint Test W |
| B10C5:24 | Trunk Unlock Pull Switch: Signal Stuck High | If equipped with a manual liftgate, GO to Pinpoint Test N If equipped with a power liftgate, REFER to: Body Closures . |
| B10C6:1F | Exterior Trunk Antenna: Circuit Intermittent | GO to Pinpoint Test X |
| B10D1:24 | Left Front Lock Button: Signal Stuck High | GO to Pinpoint Test W |
| B10D3:24 | Right Front Lock Button: Signal Stuck High | GO to Pinpoint Test W |
| B1361:31 | Front Right Door Handle Lock Circuit: No Signal | GO to Pinpoint Test W |
| B1365:31 | Front Left Door Handle Lock Circuit: No Signal | GO to Pinpoint Test W |
| B136F:31 | Left Front Door Handle Unlock Circuit: No Signal | GO to Pinpoint Test W |
| B1370:23 | Door Handle Ground Supply: Signal Stuck Low | GO to Pinpoint Test W |
| B1370:24 | Door Handle Ground Supply: Signal Stuck High | GO to Pinpoint Test W |
| B1373:31 | Front Right Door Handle Unlock Circuit: No Signal | GO to Pinpoint Test W |
| U201F:00 | External Receiver: No Sub Type Information | GO to Pinpoint Test R |
| U201F:13 | External Receiver: Circuit Open | GO to Pinpoint Test R |
| U201F:87 | External Receiver: Missing Message | GO to Pinpoint Test R |
| All other DTCs | - | REFER to: Remote Function Actuator (RFA) Module . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
