Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Ford Transit Connect TitaniumFACTORY OEM SERVICE PROCEDURE
Adaptive Learning Drive Cycle
Configuration
NOTE:
The engine and transmission must be at normal operating temperature.
- 1.
Using the scan tool, select Powertrain under the Toolbox icon, select Transmission, then select Clear Transmission Adaptive Tables.
- 3.
With the engine running and the brake applied, select the gears in the following order, pausing in each gear for 4 seconds: N, R, N, D, R, D, N. Repeat this pattern 2 times. If any engagements feel soft or harsh, repeat this procedure.
- 4.
Drive the vehicle and accelerate at a moderate throttle so that the upshifts occur at 2, 000 rpm up to 80 km/h (50 mph) and brake moderately to a stop. Repeat this pattern 2 times.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
