2016 Ford Transit Connect TitaniumFACTORY OEM SERVICE PROCEDURE

Disassembly And Assembly Of Subassemblies: Differential: Assembly

  1. 1.

    Clean and inspect the side gears and spider gears and washers for damage or excessive wear and install new components as necessary.
GFD150213Courtesy of FORD MOTOR COMPANY

  1. 2.

    Clean and inspect the differential pin for damage or excessive wear and install new if necessary.
GFD150214Courtesy of FORD MOTOR COMPANY

  1. 3.

    Check that bearings spin freely and do not move back and forth or side to side excessively.
GFD150215Courtesy of FORD MOTOR COMPANY

  1. 4.

    Install the washers on the side or spider gears that they were removed from.
GFD150216Courtesy of FORD MOTOR COMPANY

  1. 5.

    Position the side gears in the differential carrier.
GFD150217Courtesy of FORD MOTOR COMPANY

  1. 6.

    Place the spider gears in the differential carrier and rotate the side gears with the spider gears until the differential pin hole lines up to the holes in the spider gears.
GFD150218Courtesy of FORD MOTOR COMPANY

  1. 7.

    Install the differential pin with the roll pin holes aligned.
GFD150219Courtesy of FORD MOTOR COMPANY

  1. 8.

    Install a new roll pin. Use the General Equipment: Punch
GFD150220Courtesy of FORD MOTOR COMPANY
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.