Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Ford Taurus SHOFACTORY OEM SERVICE PROCEDURE
Starting System DTCS: Pcm
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| P0512 | Starter Request Circuit | CARRY OUT the Ignition Switch component test. Refer to Component Testing for component testing. If necessary, INSTALL a new ignition switch. REFER to Steering Column Switches . If the ignition switch passed the component test, REPAIR circuit CDC35 (BU/WH) for a short to voltage. |
| P06E9 | Engine Starter Performance | If the engine cranks, REFER to Engine Controls - Powertrain DTC Charts & Descriptions (Except Diesel & Hybrid) . If the engine does not crank, for vehicles without push button start, GO to Pinpoint Test A . For vehicles with push button start, GO to Pinpoint Test B . |
| P0706 | Transmission Range Sensor "A" Circuit Range/Performance | REFER to Automatic Transmission 6F50/6F55 or REFER to Automatic Transmission 6F35 . |
| P0708 | Transmission Range Sensor "A" Circuit High | REFER to Automatic Transmission 6F50/6F55 or REFER to Automatic Transmission 6F35 . |
| P1594 | Forced Engine Shutdown - Remote Start System Fault, No Unattended Vehicle Timeout | GO to Pinpoint Test H . |
| P1595 | Forced Engine Shutdown - Remote Start System Fault, Transmission Range Not In Park Position | GO to Pinpoint Test I . |
| P161A | Incorrect Response From Immobilizer Control Module | REFER to Anti-Theft Passive Anti-Theft System (PATS) Without Intelligent Access or REFER to Anti-Theft Passive Anti-Theft System (PATS) With Intelligent Access . |
| P162F | Starter Motor Disabled - Engine Crank Time Too Long | This DTC sets in the PCM when the engine has been cranked for more than a total of 60 seconds without allowing sufficient time for the starter to cool. Diagnose all other DTCs and symptoms. Check the charging system voltage and correct as necessary. Clear the DTC. |
| P1702 | Transmission Range Sensor Circuit Intermittent | REFER to Automatic Transmission 6F50/6F55 or REFER to Automatic Transmission 6F35 . |
| P1705 | Transmission Range Circuit Not Indicating Park/Neutral During Self Test | REFER to Automatic Transmission 6F50/6F55 or REFER to Automatic Transmission 6F35 . |
| P2535 | Ignition Switch Run/Start Position Circuit High | GO to Pinpoint Test G . |
| All Other DTCs | - | REFER to Electronic Engine Controls . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.