2016 Ford Fusion Titanium, AWDFACTORY OEM SERVICE PROCEDURE

Repair procedures: Installation

WARNING: This page is about a different car, the 2013 Hyundai Elantra GT. However, it is still accessible from the selected car via links, so may be relevant.
  1. The TDC marks of the intake and exhaust CVVT sprockets are slightly turned from the TDC position as illustrated when the timing chain is removed.
    Fig 1: Identifying Intake And Exhaust CVVT Sprockets TDC Marks
    G09885429Courtesy of HYUNDAI MOTOR AMERICA
  2. Turn the crankshaft clockwise (about 2~3 pitches) from the TDC position (the dowel pin (A) of crankshaft is about 3Β° with the engine vertical line) as rotation of the intake CVVT sprocket from the TDC position.
    Fig 2: Identifying Crankshaft TDC Position
    G09885430Courtesy of HYUNDAI MOTOR AMERICA
  3. Install the timing chain guide (A).

    Tightening torque:Β 

    18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

    Fig 3: Identifying Timing Chain Guide
    G09885431Courtesy of HYUNDAI MOTOR AMERICA
  4. Install the timing chain tensioner arm (A).

    Tightening torque:Β 

    18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

    Fig 4: Identifying Timing Chain Tensioner Arm
    G09885432Courtesy of HYUNDAI MOTOR AMERICA
  5. Install the timing chain.

    Crankshaft sprocket (A) β†’ Timing chain guide (B) β†’ Intake CVVT sprocket (C) β†’ Exhaust CVVT sprocket (D)

    1. Install the timing chain with no slack between the crankshaft sprocket and the intake CVVT sprocket.
      Fig 5: Identifying Timing Chain
      G09885433Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.