2016 Ford Fusion Energi TitaniumFACTORY OEM SERVICE PROCEDURE

Powertrain Control Module (Pcm)

DTC INDEX

DTC Description Action
P0504 Brake Switch "A" / "B" Correlation GO to Pinpoint Test D
P0572 Brake Switch "A" Circuit Low GO to Pinpoint Test D
P0573 Brake Switch "A" Circuit High GO to Pinpoint Test D
P1703 Brake Switch Out Of Self-Test Range GO to Pinpoint Test D
P08A9 Clutch Pedal Sensor 1, Out of Limits LOW GO to Pinpoint Test C
P08AA Clutch Pedal Sensor 1, Out of Limits HIGH GO to Pinpoint Test C
P08B6 Clutch Pedal Sensor 2, Out of Limits LOW GO to Pinpoint Test C
P08B7 Clutch Pedal Sensor 2, Out of Limits HIGH GO to Pinpoint Test C
P08B9 Clutch Pedal Sensor 1 and 2 Do Not Match Expected Values GO to Pinpoint Test C
U0104 Lost Communication With Cruise Control Module GO to Pinpoint Test G
U0121 Lost Communication With Anti-Lock Brake System (ABS) Control Module For non-adaptive cruise control, GO to Pinpoint Test E For adaptive cruise control, GO to Pinpoint Test F
All other Diagnostic Trouble Codes (DTCs) - Refer to the appropriate Engine article for the procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.