Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Ford Focus STFACTORY OEM SERVICE PROCEDURE
Powertrain Control Module (PCM) DTC Table
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| P0125 | Insufficient Coolant Temp For Closed Loop Fuel Control | GO to Pinpoint Test C |
| P0128 | Coolant Thermostat (Coolant Temp Below Thermostat Regulating Temperature) | GO to Pinpoint Test C |
| P0217 | Engine Coolant Overtemperature Condition | GO to Pinpoint Test B |
| P0480 | Fan 1 Control Circuit | Refer to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) |
| P0481 | Fan 2 Control Circuit | Refer to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) |
| P0691 | Fan 1 Control Circuit Low | Refer to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) |
| P0692 | Fan 1 Control Circuit High | Refer to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) |
| P0693 | Fan 2 Control Circuit Low | Refer to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) |
| P0694 | Fan 2 Control Circuit High | Refer to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) |
| P1285 | Cylinder Head Overtemperature Condition | GO to Pinpoint Test B |
| P1299 | Cylinder Head Overtemperature Protection Active | GO to Pinpoint Test B |
| All Other PCM Diagnostic Trouble Codes (DTCs) | - | REFER to: Electronic Engine Controls |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.