2016 Ford Focus STFACTORY OEM SERVICE PROCEDURE

Powertrain Control Module (PCM) DTC Table

DTC INDEX

DTC Description Action
P0125 Insufficient Coolant Temp For Closed Loop Fuel Control GO to Pinpoint Test C
P0128 Coolant Thermostat (Coolant Temp Below Thermostat Regulating Temperature) GO to Pinpoint Test C
P0217 Engine Coolant Overtemperature Condition GO to Pinpoint Test B
P0480 Fan 1 Control Circuit Refer to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID)
P2600 Coolant Pump "A" Control Circuit/Open GO to Pinpoint Test D
P2601 Coolant Pump "A" Control Circuit Performance/Stuck Off GO to Pinpoint Test D
P2602 Coolant Pump "A" Control Circuit Low GO to Pinpoint Test D
P2603 Coolant Pump "A" Control Circuit High GO to Pinpoint Test D
All Other PCM Diagnostic Trouble Codes (DTCs) - REFER to: Electronic Engine Controls
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.