Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Ford Flex SEFACTORY OEM SERVICE PROCEDURE
Steering Column Control Module (SCCM)
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1368:11 | Adjustable Pedal Position Feedback Sensor: Circuit Short to Ground | GO to Pinpoint Test A . |
| B1368:12 | Adjustable Pedal Position Feedback Sensor: Circuit Short to Battery | GO to Pinpoint Test A . |
| B1369:09 | Pedal Adjustment Switch: Component Failure | INSTALL a new adjustable pedals control switch. REFER to Adjustable Pedals Control Switch . TEST the system for normal operation. If the concern still exists, INSTALL a new SCCM. REFER to Steering Column Switches . |
| B137D:18 | Pedal Adjustment Motor: Circuit Current Below Threshold | GO to Pinpoint Test B |
| B137D:19 | Pedal Adjustment Motor: Circuit Current Above Threshold | GO to Pinpoint Test B |
| B137D:71 | Pedal Adjustment Motor: Actuator Stuck | GO to Pinpoint Test B |
| - | All Other SCCM DTCs | REFER to Steering Column Switches . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
