2016 Ford Flex SEFACTORY OEM SERVICE PROCEDURE

Torque Specifications

Description Nm lb-ft lb-in
Front Seat 
Power recliner motor bolt 5 - 44
Safety belt anchor bolt 40 30 -
Safety belt buckle pretensioner bolt 40 30 -
Seat front mounting bolts(1) - - -
Seat rear mounting bolts(1) - - -
Side air bag module-to-backrest frame nut 10 - 89
Rear Seat, Second Row 
Armrest-to-backrest screws, 60 percent seat 20 - 177
Backrest pivot bolt, 60 percent seat(1) - - -
Cushion frame-to-riser bolts, 60 percent seat 48 35 -
Cushion frame-to-riser/seat track nuts 23 17 -
Cushion frame yoke-to-riser bolt, 60 percent seat 48 35 -
Floor studs 28 21 -
Hinge assembly-to-cushion frame bolts, 60 percent seat 48 35 -
Inboard striker-to-floor bolts 80 59 -
Latch foot bolts 32 24 -
Outboard recliner-to-backrest frame bolts, 60 percent seat 48 35 -
Outboard recliner-to-cushion frame bolts, 60 percent seat 48 35 -
Outboard striker-to-floor bolts 48 35 -
Recliner-to-backrest frame bolts, 40 percent seat 48 35 -
Recliner-to-cushion frame bolts, 40 percent seat 50 37 -
Safety belt anchor-to-inboard recliner bolt, 60 percent seat 40 30 -
Safety belt buckle bolt, 60 percent or 40 percent seat 40 30 -
Safety belt guide bolts, 60 percent seat 48 35 -
Safety belt retractor-to-safety belt guide bolt, 60 percent seat 40 30 -
Rear Seat, Third Row 
Backrest latch-to-backrest frame bolts 90 66 -
Backrest latch-to-cushion frame bolts 60 44 -
Cushion floor striker-to-floor pan bolts 23 17 -
Cushion frame-to-pivot tube assembly bolts 60 44 -
Floor latch bolts 30 22 -
Head restraint-to-backrest frame nuts 24 18 -
Head restraint bolts 4 - 35
Load floor support-to-floor pan nuts 18 - 159
Pivot bolt 50 37 -
Safety belt buckle bolt 40 30 -
Seat mounting bracket-to-floor bolts 80 59 -

(1) Refer to the appropriate procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.