Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Ford Fiesta Titanium, 4D Hatchback, Automatic DCT TransFACTORY OEM SERVICE PROCEDURE
Powertrain Control Module (PCM)
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| P0532 | A/C Refrigerant Pressure Sensor "A" Circuit Low | For 1.0L EcoBoost, GO to Pinpoint Test A For 1.6L EcoBoost, GO to Pinpoint Test B For 1.6L Duratec-16V Ti-VCT, GO to Pinpoint Test C |
| P0533 | A/C Refrigerant Pressure Sensor "A" Circuit High | For 1.0L EcoBoost, GO to Pinpoint Test A For 1.6L EcoBoost, GO to Pinpoint Test B For 1.6L Duratec-16V Ti-VCT, GO to Pinpoint Test C |
| P0645 | A/C Clutch Relay Control Circuit | For 1.0L EcoBoost, GO to Pinpoint Test D For 1.6L EcoBoost, GO to Pinpoint Test E For 1.6L Duratec-16V Ti-VCT, GO to Pinpoint Test F |
| P0646 | A/C Clutch Relay Control Circuit Low | For 1.0L EcoBoost, GO to Pinpoint Test D For 1.6L EcoBoost, GO to Pinpoint Test E For 1.6L Duratec-16V Ti-VCT, GO to Pinpoint Test F |
| P0647 | A/C Clutch Relay Control Circuit High | For 1.0L EcoBoost, GO to Pinpoint Test D For 1.6L EcoBoost, GO to Pinpoint Test E For 1.6L Duratec-16V Ti-VCT, GO to Pinpoint Test F |
| P06A0 | Variable A/C Compressor Control Circuit | GO to Pinpoint Test Y |
| P1464 | A/C Demand Out Of Self Test Range | GO to Pinpoint Test L |
| P193E | A/C Clutch Request Signal | GO to Pinpoint Test Z |
| PCM Diagnostic Trouble Codes (DTCs) | PCM Diagnostic Trouble Codes (DTCs) not listed in this chart | For 1.0L EcoBoost, REFER to: Electronic Engine Controls
. For 1.6L EcoBoost, REFER to: Electronic Engine Controls . For 1.6L Duratec-16V Ti-VCT, REFER to: Electronic Engine Controls . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
