Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Ford Fiesta STFACTORY OEM SERVICE PROCEDURE
Electronic Engine Controls System - 1.6L ECOBOOST (132KW/180PS) - Sigma
- Description And Operation
- Diagnosis And Testing
- Removal And Installation
- Camshaft Position (CMP) Sensor LH
- Camshaft Position (CMP) Sensor RH
- Crankshaft Position (CKP) Sensor
- Powertrain Control Module (PCM)
- Front Knock Sensor (KS)
- Rear Knock Sensor (KS)
- Variable Camshaft Timing (VCT) Oil Control Solenoid
- Heated Oxygen Sensor (HO2S)
- Catalyst Monitor Sensor
- Engine Coolant Temperature (ECT) Sensor
- Clutch Pedal Position (CPP) Switch
- Fuel Rail Pressure (FRP) Sensor
- Intake Air Temperature (IAT) Sensor
- Manifold Absolute Pressure (MAP) Sensor
- Turbocharger Boost Pressure (TCBP) and Charger Air Cooler Temperature (CACT) Sensor
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
