Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmission Strategy Download
Programming
- 1.
If a new main control was installed, record the 12-digit solenoid body identification and 13-digit solenoid body strategy from the replacement solenoid body tag provided with the main control service kit. Place the replacement tag over the existing identification tag.- 13 - digit solenoid body strategy
- 12 - digit solenoid body identification
- 2.
Using the scan tool, select module Programming and Programmable Parameters under the toolbox icon and select transmission. Follow the instructions displayed on the scan tool. There are fields to enter the solenoid body 12-digit identification and 13-digit strategy recorded from the solenoid body.
- 3.NOTE: If the solenoid body information is not correct, transmission damage or driveability concerns can occur.
Enter the solenoid body 13-digit strategy. The scan tool verifies the numbers entered are valid and display a message if the information is not valid. The scan tool will check to verify the file is present on the scan tool. If the file is present, the technician may proceed with downloading the file to the module. If the file is not present, the scan tool will need to be connected to the Professional Technician Society (PTS) server to download the file onto the scan tool.
- 4.
Verify the file is present on the scan tool. If the file is present, go to Step 8. If the file is not present, continue with this procedure.
- 7.
If the scan tool cannot connect to the Professional Technician Society (PTS) server, download the file from Professional Technician Society (PTS) using the OASIS tab and select the transmission strategy. If the scan tool cannot download a strategy from the web site, a partial strategy will automatically be downloaded.
- 10.
The scan tool automatically downloads the strategy file or partial strategy file to the module. The scan tool displays a message when it is finished downloading the data that states that the file was downloaded successfully.
- 11.NOTE: If a drive cycle is not completed, erratic shifts and driveability concerns may occur.
Road test the vehicle following the Adaptive Learning Drive Cycle. Refer to: Adaptive Learning Drive Cycle .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
