Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2015 Ford Transit Connect TitaniumFACTORY OEM SERVICE PROCEDURE
Rear View Mirror DTCS: DDM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B11BD:11 | Mirror Fold Relay: Circuit Short To Ground | GO to Pinpoint Test E |
| B11BD:15 | Mirror Fold Relay: Circuit Short To Battery or Open | GO to Pinpoint Test E |
| B12D8:11 | Mirror Heater Output: Circuit Short To Ground | GO to Pinpoint Test D |
| B12D8:15 | Mirror Heater Output: Circuit Short To Battery or Open | GO to Pinpoint Test D |
| B1302:11 | Mirror Motor Common: Circuit Short To Ground | GO to Pinpoint Test B |
| B1302:15 | Mirror Motor Common: Circuit Short To Battery or Open | GO to Pinpoint Test B |
| B1C09:11 | Driver Left/Right Mirror Motor: Circuit Short To Ground | GO to Pinpoint Test B |
| B1C09:15 | Driver Left/Right Mirror Motor: Circuit Short To Battery or Open | GO to Pinpoint Test B |
| B1C10:11 | Driver Up/Down Mirror Motor: Circuit Short To Ground | GO to Pinpoint Test B |
| B1C10:15 | Driver Up/Down Mirror Motor: Circuit Short To Battery or Open | GO to Pinpoint Test B |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: Locks, Latches and Entry Systems - Vehicles With: One-Touch Open and Close Front Windows |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.