WARNING: This page is about a different car, the 2016 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

The chart describes specific module configuration information:

Module Name	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Progammable Parameters
APIM	Yes	Yes	No	None
ABS module	Yes	Yes	IVD initialization	None
ACM	Yes	Yes	No	Radio presets
BCM	Yes	Yes	Ambient lighting calibration Rear view camera calibration	DRL configuration Keyless entry/passive start configuration Remote start enable/disable Trim switch enable/disable
CCM	Yes	Yes	No	None
DSP	Yes	Yes	No	None
DC/ DC Converter Control Module (Voltage Quality Module)	Yes	Yes	No	None
DDM	Yes	Yes	No	None
DSM	Yes	Yes	No	None
FCIM	Yes	Yes	No	None
FCDIM (4.2-inch screen)	Yes	Yes	No	None
SCME	Yes	Yes	No	None
GWM	Yes	Yes	No	None
GPSM	Yes	Yes	No	None
HUD Module	No	No	No	None
HSWM	Yes	Yes	No	None
IPMA	Yes	Yes	Camera calibration	None
IPC	Yes	Yes	No	Automatic engine ignition shutdown (AEIS) with override Daytime running lamps (DRLs) control function Driver Beltminder Mid-passenger Beltminder Passenger Beltminder Remote start enable/disable climate settings driver seat passenger seat rear defrost
OCSM	No	No	OCSM re-zero	None
PAM (integrated with BCM)	Yes	Yes	No	None
PSCM	Yes	Yes	No	None
PCM	No	Yes	No	None
PDM	Yes	Yes	No	None
RTM	Yes	Yes	No	None
RCM	Yes	Yes	No	None
SODL	Yes	Yes	No	Blockage enabled Enable/disable configuration
SODR	Yes	Yes	No	Blockage enabled Enable/disable configuration
SCCM	Yes	Yes	No	None
Tracking and Blocking System (TBS) Module (Brazil only)	Yes	Yes	No	Maintenance mode set

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Module Configuration and Parameter Chart

Use the Manual With the Right Hardware

When to See a Mechanic