2015 Ford Fusion Energi TitaniumFACTORY OEM SERVICE PROCEDURE

Fuel Tank Isolation Valve: Notes

The fuel tank isolation valve is mounted behind the fuel tank, near the EVAP canister. The fuel tank isolation valve is a PCM controlled solenoid that isolates the fuel tank from the rest of the EVAP system. The fuel tank isolation valve is a normally closed valve blocking the flow of vapors from the fuel tank to the EVAP purge valve and the EVAP canister. This prevents the canister from becoming saturated causing hydrocarbons (HC) to be released into the atmosphere in a situation where the engine does not run during a drive cycle. The PCM opens the fuel tank isolation valve during refueling. The fuel tank isolation valve will automatically open to relieve excess pressure or vacuum if the fuel tank pressure or vacuum reaches a maximum calibrated value.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.