2015 Ford Explorer SportFACTORY OEM SERVICE PROCEDURE

Wiper System And Washer System DTCS

DTC INDEX

DTC Description Action
B10AD:02 Rain Sensor: General Signal Failure GO to Pinpoint Test G .
B10AD:08 Rain Sensor: Bus Signal / Message Failure If the windshield wipers only operate in high speed mode, GO to Pinpoint Test F . If the rain sensitive wiper function is inoperative, GO to Pinpoint Test G .
B1131:02 Wiper Motor Module: General Signal Failure If the windshield wipers are inoperative, GO to Pinpoint Test A . If the windshield wipers only operate in high speed mode, GO to Pinpoint Test F .
B1131:08 Wiper Motor Module: Bus Signal / Message Failure If the windshield wipers are inoperative, GO to Pinpoint Test A . If the windshield wipers only operate in high speed mode, GO to Pinpoint Test F .
All other SCCM DTCs - REFER to REFER to Steering Column Switches .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.