Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2015 Ford Explorer SportFACTORY OEM SERVICE PROCEDURE
Establishing An IDS Session
WARNING: This page is about a different car, the 2015 Lincoln Navigator and 2015 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
General Procedure
- 2.
Turn ignition to RUN.
NOTE:
For vehicles with push-button start, refer to Description and Operation in Steering Column Switches
.
- 3.
The diagnostic scan tool first attempts to communicate with the PCM. After establishing communication with the PCM, the diagnostic scan tool then attempts to communicate with all other modules on the vehicle.
- 4.
If an IDS session cannot be established with the vehicle, IDS may state "No communication can be established with the PCM."
- 6.
Enter either a PCM part number, tear tag or calibration number to identify the vehicle and start a session. The PCM part number and 4-character tear tag number are printed on the PCM label. If the PCM part number or tear tag number cannot be found, double-click on the VIN in the upper RH corner of the PTS screen. The tear tag number is listed on the Detailed Vehicle Specification.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
