Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2015 Ford Explorer SportFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System (Abs) And Stability Control
- Specifications
- Description And Operation
- Diagnosis And Testing
- Anti-Lock Brake System (ABS) and Stability Control
- DTC Chart: ABS Module
- Symptom Chart: Vehicle Dynamic Systems
- Pinpoint Tests
- Pinpoint Test A : U3003:16
- PINPOINT TEST B : Wheel Speed Sensor Erratic Signal Faults
- Pinpoint Test C : C0044:28, C0044:49, C0044:64
- Pinpoint Test E : C0040:64
- Pinpoint Test F : U0100:00
- Pinpoint Test G : U0104:00
- Pinpoint Test I : U0140:00
- Pinpoint Test K : U0151:00, U0151:88
- Pinpoint Test L : U3002:62
- PINPOINT TEST M : The Traction Control System Cannot Be Disabled
- Pinpoint Test P : U3003:17
- Pinpoint Test Q : C101A:1C, C101A:2A, C101A:2F, C101A:62
- Pinpoint Test S : U0131:00
- Pinpoint Test T : U0138:00
- Pinpoint Test V : C0020:13, C0020:71
- PINPOINT TEST W : Stability Control Sensor Signal Failure Faults
- Pinpoint Test AE : C1B14:11, C1B14:12, U3000:47
- PINPOINT TEST AJ : Wheel Speed Sensor Electrical Faults - Front
- PINPOINT TEST AK : Wheel Speed Sensor Electrical Faults - Rear
- Pinpoint Test Al : U3000:41
- Pinpoint Test Am : C1B00:29, C1B00:41, C1B00:64, C1B00:86
- Anti-Lock Brake System (ABS) and Stability Control
- Removal And Installation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.