The charts describe specific module configuration information:

Module Configuration and Parameter Chart (Except BCM and IPC)

Module Name	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Progammable Parameters
ABS module	Yes	Yes	IVD initialization Lateral sensor calibration Longitudinal sensor calibration Pressure sensor calibration Central configuration data parameter learning	None
APIM	Yes	Yes	No	Date format Rear camera
ACM	Yes	Yes	No	None
DSP	Yes	Yes	No	None
DDM	No	Yes	Window AUTO up/down functionality	None
DSM	No	Yes	No	None
FCIM	No	Yes	No	None
FCDIM	Yes	Yes	No	None
GPSM (if equipped)	Yes	Yes	No	None
HCM	No	Yes	No	None
HVAC module	No	Yes	No	None
IPMB (if equipped)	Yes	Yes	No	None
OCSM	No	Yes	Seat weight sensor re-zero	None
PAM	No	Yes	No	None
PDM	No	No	Window AUTO up/down functionality	None
PSCM	No	Yes	No	None
PCM	Yes	Yes	No	None
RGTM	No	Yes	No	None
RFA module	No	Yes	No	None
RCM	Yes	Yes	No	None
SODL	No	Yes	No	None
SODR	No	Yes	No	None
SASM	No	No	No	None
TRM	No	Yes	No	None

Body Control Module (BCM) and Instrument Panel Cluster (IPC)

NOTE: The Body Control Module (BCM) and IPC have a unique procedure to set Car Configuration Parameters. Configuration changes made will affect both modules. On the scan tool, first select Module Programming > Programmable Parameters > Car Configuration Parameter(s) > Vehicle Configuration > Retrieve the Vehicle Configuration Data. Next select Module Programming > Programmable Parameters > Car Configuration Parameter(s) > Vehicle Configuration > Modify and Reinstate Vehicle Configuration Data. Change parameters as needed.

Module Name	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Car Configuration Parameters
BCM	Yes (through Car Configuration Parameters. Refer to Body Control Module (BCM) .	Yes	No	NOTE: Do not change car configuration parameters except those listed below. Courtesy wipe disableBLIS® enable/disableLoud speaker quantities (6, 9 or 10)LanguagePark assist cameraRemote start enable/disableTire sizeTowbarTrailer moduleTrailer stability assist
IPC	Yes	Yes	No

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Module Configuration and Parameter Chart

Use the Manual With the Right Hardware

When to See a Mechanic