2015 Ford Edge Sport, AWDFACTORY OEM SERVICE PROCEDURE

Pinpoint Tests: Notes

Pinpoint Test A: DTC B1319:11 

Refer to SHIFT INTERLOCK for schematic and connector information.

Normal Operation and Fault Conditions 

The BCM provides power to the Brake Shift Interlock Actuator (BSIA). When the BCM receives a brake pedal applied input, voltage is applied to the brake shift interlock solenoid. When the solenoid is energized, the plunger is pulled inward allowing the selector lever to move from the park position.

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
B1319:11 Brake Shift Interlock Output Circuit Short To Ground Short to ground in the Brake Shift Interlock Actuator (BSIA) circuitry.

Possible Sources 

  • Circuitry shorted to ground
  • BCM
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.