2015 Ford C-Max Energi SELFACTORY OEM SERVICE PROCEDURE

Body Control Module (BCM)

DTC INDEX

DTC Description Action
B102F:2F Auxiliary Switch: Signal Erratic GO to Pinpoint Test B
B108A:24 Start Button: Signal Stuck High GO to Pinpoint Test E
B108B:23 Start Button Circuit "A": Signal Stuck Low GO to Pinpoint Test E
B108B:24 Start Button Circuit "A": Signal Stuck High GO to Pinpoint Test E
B108B:2F Start Button Circuit "A": Signal Erratic GO to Pinpoint Test E
B108C:23 Start Button Circuit "B": Signal Stuck Low GO to Pinpoint Test E
B108C:24 Start Button Circuit "B": Signal Stuck High GO to Pinpoint Test E
B108C:2F Start Button Circuit "B": Signal Erratic GO to Pinpoint Test E
B10E7:12 Ignition On Relay: Circuit Short To Battery For vehicles equipped with a conventional ignition switch, GO to Pinpoint Test C
For vehicles equipped with push button start, GO to Pinpoint Test E
B10E7:14 Ignition On Relay: Circuit Short To Ground or Open For vehicles equipped with a conventional ignition switch, GO to Pinpoint Test C
For vehicles equipped with push button start, GO to Pinpoint Test E
B10FF:12 Ignition Control: Circuit Short To Battery For vehicles equipped with a conventional ignition switch, GO to Pinpoint Test C
For vehicles equipped with push button start, GO to Pinpoint Test E
B10FF:14 Ignition Control: Circuit Short To Ground or Open For vehicles equipped with a conventional ignition switch, GO to Pinpoint Test C
For vehicles equipped with push button start, GO to Pinpoint Test E
B112A:12 Ignition On Relay B: Circuit Short To Battery For vehicles equipped with a conventional ignition switch, GO to Pinpoint Test C
For vehicles equipped with push button start, GO to Pinpoint Test E
U300A:13 Ignition Switch: Circuit Open GO to Pinpoint Test C
All other DTCs - REFER to: Body Control Module (BCM) .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.