2014 Ford Taurus SHOFACTORY OEM SERVICE PROCEDURE

Body Control Module (BCM)

DTC INDEX

DTC Description Action
B108A:01 Start Button: General Electrical Failure GO to PINPOINT TEST J .
B1142:29 Ignition Status 1: Signal Invalid GO to PINPOINT TEST J .
B1240:11 Start Button Mode Indicator: Circuit Short to Ground GO to PINPOINT TEST I .
B1240:15 Start Button Mode Indicator: Circuit Short to Battery or Open GO to PINPOINT TEST I .
B1310:12 Run/Start Control: Circuit Short to Battery GO to PINPOINT TEST O .
B1310:14 Run/Start Control: Circuit Short to Ground or Open For vehicles equipped with an ignition switch, GO to PINPOINT TEST C .
For vehicles equipped with a start/stop switch, GO to PINPOINT TEST E .
U300A:01 Ignition Switch: General Electric Failure GO to PINPOINT TEST A .
All other BCM DTCs - REFER to MULTIFUNCTION ELECTRONIC MODULES .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.