Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Ford Taurus SHOFACTORY OEM SERVICE PROCEDURE
Driver Door Module (DDM)
DTC INDEX
| DTC | Description | Retrieved | Action |
|---|---|---|---|
| B1534 | Memory 1 Switch Circuit Short to Ground | On-Demand and Continuous | Seat without massage, GO to PINPOINT TEST N . Seat with massage, GO to PINPOINT TEST P . |
| B1538 | Memory 2 Switch Circuit Short to Ground | On-Demand and Continuous | Seat without massage, GO to PINPOINT TEST N . Seat with massage, GO to PINPOINT TEST P . |
| All Other DTCs | - | On-Demand and Continuous | REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS - WITH INTELLIGENT ACCESS (IA) . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.