Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Ford Fusion Titanium, FWDFACTORY OEM SERVICE PROCEDURE
Front Controls Interface Module (FCIM) DTC Table
FCIM DTC CHART
| DTC | Description | Action |
|---|---|---|
| B1C83:11 | Rear Defog Relay: Circuit Short to Ground | GO to PINPOINT TEST B |
| B1C83:12 | Rear Defog Relay: Circuit Short to Battery | GO to PINPOINT TEST A |
| B1C83:13 | Rear Defog Relay: Circuit Open | GO to PINPOINT TEST A |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: CLIMATE CONTROL SYSTEM - VEHICLES WITH: DUAL AUTOMATIC TEMPERATURE CONTROL (DATC)
. REFER to: CLIMATE CONTROL SYSTEM - VEHICLES WITH: ELECTRONIC MANUAL TEMPERATURE CONTROL (EMTC) . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.