Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Ford Fusion Energi TitaniumFACTORY OEM SERVICE PROCEDURE
Test Procedure
- HU1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS)
Is DTC P0505 or P0506 present?
Yes No GO to HU2 . For symptoms without DTCs, GO to HU2 .
For all others, RETURN to ENGINE CONTROLS - SYMPTOM CHARTS (HYBRID) for further direction. - HU2 CHECK THE INTAKE AIR SYSTEM FOR LEAKS, OBSTRUCTIONS, AND DAMAGE
- Listen for vacuum leaks from the following:
- loose connections on the intake air tube at the air cleaner housing or throttle body
- cracked or punctured intake air tube
- worn gaskets between the mass air flow (MAF) sensor and the air cleaner assembly
- vacuum supply connectors and hose
- intake manifold assembly or gasket
- exhaust gas recirculation (EGR) valve gasket leak to intake manifold
- verify the integrity of the positive crankcase ventilation (PCV) system and the correct PCV valve part number
- correctly seated engine oil dipstick, tube or oil fill cap
- aftermarket accessories and performance modifications
Are any concerns present?
Yes No REPAIR as necessary.
Clear the PCM DTCs. REPEAT the self-test.GO to HU3 . - Listen for vacuum leaks from the following:
- HU3 CHECK THE THROTTLE BODY FOR EXCESSIVE WEAR
- Ignition OFF.
- Remove the throttle body assembly. Refer to the Fuel Charging and Controls article.
- Inspect the throttle body for:
- excessive wear or grooving in the throttle bore
- misaligned or worn throttle plate
- excessive gap between the throttle bore and plate
Are any concerns present?
Yes No INSTALL a new throttle body assembly.
REFER to the Fuel Charging and Controls article.
Clear the PCM DTCs. REPEAT the self-test.RETURN to ENGINE CONTROLS - SYMPTOM CHARTS (HYBRID) for further direction.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
