Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Ford Focus Titanium, 4D Hatchback, Automatic DCT Trans, Gas/EthanolFACTORY OEM SERVICE PROCEDURE
Body Control Module (BCM) DTC Table
BCM DTC DESCRIPTION
| DTC | Description | Action |
|---|---|---|
| B1108:77 | Driver Door Central Locking Motor: Commanded Position Not Reachable | GO to PINPOINT TEST M |
| B1109:77 | Passenger Door Central Locking Motor: Commanded Position Not Reachable | GO to PINPOINT TEST M |
| B110A:77 | Rear Door Driver Side Central Locking Motor: Commanded Position Not Reachable | GO to PINPOINT TEST M |
| B110B:77 | Rear Door Passenger Side Central Locking Motor: Commanded Position Not Reachable | GO to PINPOINT TEST M |
| B1222:11 | Master Lock/Unlock Switch: Circuit Short To Ground | GO to PINPOINT TEST L |
| B1222:23 | Master Lock/Unlock Switch: Signal Stuck Low | GO to PINPOINT TEST L |
| B1287:11 | Central Lock Switch Illumination: Circuit Short to Ground | GO to PINPOINT TEST M |
| B1287:15 | Central Lock Switch Illumination: Circuit Short to Battery or Open | GO to PINPOINT TEST M |
| B12D3:23 | Driver Door Lock Status: Signal Stuck Low | GO to PINPOINT TEST M |
| B12E8:11 | Liftgate/Tailgate Control/Release Switch: Circuit Short To Ground | GO to PINPOINT TEST N |
| B12E8:23 | Liftgate/Tailgate Control/Release Switch: Signal Stuck Low | GO to PINPOINT TEST N |
| B12EA:56 | Radio Frequency (RF) Receiver: Invalid/Incompatible Configuration | INSTALL a new BCM . REFER to: BODY CONTROL MODULE (BCM) . |
| B13B0:13 | Passenger Side Front Door Unlock Switch: Circuit Open | GO to PINPOINT TEST M |
| B13B1:13 | Left Side Rear Door Unlock Switch: Circuit Open | GO to PINPOINT TEST M |
| B13B2:13 | Right Side Rear Door Unlock Switch: Circuit Open | GO to PINPOINT TEST M |
| B1D21:62 | Remote Control Switch: Signal Compare Failure | GO to PINPOINT TEST O |
| All other DTCs | - | REFER to: BODY CONTROL MODULE (BCM) . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.