Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Auto Stop Start
The auto stop start system helps reduce fuel consumption and decrease emissions by automatically shutting down the engine when the vehicle stops and the engine is idling, usually within 1500 ms (1.5 seconds). To initiate the auto stop start operation, the vehicle gear selector must be in DRIVE when the vehicle comes to a stop and the brake pedal must be fully applied. The engine automatically restarts when the brake pedal is released, usually within 200 ms (0.5 seconds), or when a vehicle system requires a restart, for example to recharge the battery or to maintain interior comfort settings.
The auto stop start system is defaulted to an ON state when the engine is started. To switch the auto stop start system OFF, press the auto stop start switch located on the center console. To turn the auto stop start system ON, press the auto stop start switch again. The auto stop start system can only be deactivated during the current ignition cycle.
The instrument panel cluster (IPC) auto stop start indicator illuminates when an auto stop start system inhibit or disable condition is present.
During normal operation the auto stop start system may not stop the engine under the following conditions:
- The A/C, heat or defrost settings are ON
- The rear defroster is ON
- The battery has a low state of charge or is below 5Β°C (41Β°F) or above 60Β°C (140Β°F)
- The maximum engine off time is exceeded
- The engine operating temperature is less than 60Β°C (140Β°F)
- The gear selector is in the PARK, REVERSE, NEUTRAL or SECOND GEAR position
- The steering wheel is turned rapidly or is at a sharp angle
- Initial vehicle speed of greater than 4 km/h (2.5 MPH) and less than 2 seconds has elapsed
- The vehicle is on a steep road grade
- Elevation is above 10, 000 feet (3, 048 meters) approximately
Any of the following conditions may result in an automatic restart of the engine:
- The blower fan speed is increased or the climate control temperature is changed
- An electrical accessory is turned ON or plugged in
- Incorrect brake vacuum
- The auto stop start switch is pressed to disable the system while the engine is stopped
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.
