2014 Ford Flex SEFACTORY OEM SERVICE PROCEDURE

Compressor Driver Module

NOTE: For information on Ford Color Coded Illustrations refer to COLOR-CODING - FORD .
  1. Remove the rear floor console refrigerator. Refer to REFRIGERATORΒ .
  2. NOTE: Do not bend the condenser tubes. The screwdriver must fit between the condenser tubes or damage may occur to the refrigerator.

    Using a long thin screwdriver, remove the Phillips screw from the compressor driver module mounting bracket.

    Fig 1: Removing Philips Screw From Compressor Driver Module Mounting Bracket
    G09575217Courtesy of FORD MOTOR CO.
  3. Disconnect the upper electrical connector from the compressor driver module.
    Fig 2: Locating Compressor Driver Module Upper Electrical Connector
    G09575218Courtesy of FORD MOTOR CO.
  4. Rotate the compressor driver module to the right and remove from the mounting bracket.
    Fig 3: Rotating Compressor Driver Module To Right
    G09575219Courtesy of FORD MOTOR CO.
  5. Disconnect the lower electrical connector from the compressor driver module.
    Fig 4: Locating Compressor Driver Module Lower Electrical Connector
    G09575220Courtesy of FORD MOTOR CO.
  6. Disconnect the compressor driver module-to-refrigerator electrical connector.
    Fig 5: Locating Compressor Driver Module-To-Refrigerator Electrical Connector
    G09575221Courtesy of FORD MOTOR CO.
  7. To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.