Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Normal Operation
The PSCM must be programmed with the correct vehicle information in order to operate correctly. Refer to MODULE CONFIGURATION SYSTEM for additional module configuration information.
This test generates a RVC for a new PSCM when directed to do so from pinpoint test.
AA1: CHECK VEHICLE HISTORY
Check the vehicle history for recent service actions related to the PSCM or steering gear.
Have there been any recent service actions related to the PSCM or steering gear?
| Yes | No |
|---|---|
| REPEAT the PMI procedure as directed by the diagnostic scan tool or CONFIGURE the PSCM using the vehicle as-built data. | Go to AA2. |
AA2: VERIFY THE PSCM DTC
Clear the PSCM DTCs.
Ignition OFF.
Wait at least 90 seconds for the modules to completely shut off.
Ignition ON, engine OFF.
Press Read Vehicle Information button to retrieve DTCs from the vehicle.
Does the DTC return?
| Yes | No |
|---|---|
| Go to AA3. | The condition causing the DTC is not present at this time. |
AA3: OBTAIN PSCM RVC
Obtain the PSCM RVC: In order to claim the SLTS labor operation for completion of the PSCM testing, the code obtained through the link below must be included on the associated warranty claim.
INSTALL a new PSCM.
REFER to Steering Gear .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
