2014 Ford Fiesta STFACTORY OEM SERVICE PROCEDURE

Wiper System And Washer System DTCS

BCM DTC CHART

DTC Description Action
B1008:92 Wiper Mode Switch: Performance or Incorrect Operation DIAGNOSE the symptom. REFER to the SYMPTOM CHART: WIPERS AND WASHERS .
B1051:92 Front Washer Switch: Performance or Incorrect Operation
B1052:92 Rear Washer Switch: Performance or Incorrect Operation
B10AD:96 Rain sensor: Component Internal Failure INSTALL a new rain sensor. REFER to: RAIN SENSOR .
B11DC:92 Rear Wiper Mode Switch: Performance or Incorrect Operation GO to PINPOINT TEST J
B1C45:24 Front Wiper Park Position Switch: Signal Stuck High DIAGNOSE all other BCM  Diagnostic Trouble Codes (DTCs) first. If no other DTC  is present, GO to PINPOINT TEST G
B1C53:13 Front Wiper Intermittent Data: Circuit Open
  • If the vehicle is not equipped with rain sensitive wipers, GO to PINPOINT TEST B
  • If the vehicle is equipped with rain sensitive wipers, GO to PINPOINT TEST C
U0231:87 Lost Communication With Rain Sensing Module: Missing Message GO to PINPOINT TEST C
All other Diagnostic Trouble Codes (DTCs) - REFER to: BODY CONTROL MODULE (BCM) .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.