Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Ford F-150 FX4, 2D PickupFACTORY OEM SERVICE PROCEDURE
Front Display Interface Module (FDIM)
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1318 | Battery Voltage Low | GO to PINPOINT TEST Z . |
| B1342 | ECU is Faulted |
NOTE:
Repair all other DTCs before diagnosing DTC B1342.
|
| B2477 | Module Configuration Failure | CHECK vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI
procedures. If there have been recent service actions with this module, REPEAT/PERFORM the PMI
procedure as directed by the diagnostic scan tool. For more information, REFER to Programmable Module Installation (PMI) in MODULE CONFIGURATION
. If there have been no recent service actions, INSTALL a new FDIM to correct the failure to retain configuration data. REFER to FRONT DISPLAY INTERFACE MODULE (FDIM) . |
| U0140 | Lost Communication with Body Control Module (GEM ) | GO to PINPOINT TEST AB . |
| U0155 | Lost Communication with Instrument Panel Cluster (IPC ) Control Panel | GO to PINPOINT TEST AD . |
| U0164 | Lost Communication With HVAC Control Module (EATC ) | GO to PINPOINT TEST AG . |
| U0184 | Lost Communication With Radio (ACM ) | GO to PINPOINT TEST AH . |
| U0197 | Lost Communication with Telephone Control Module | GO to PINPOINT TEST AJ . |
| U2050 | No Application Present | CHECK vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI
procedures. If there have been recent service actions with this module, REPEAT/PERFORM the PMI
procedure as directed by the diagnostic scan tool. For more information, REFER to Programmable Module Installation (PMI) in MODULE CONFIGURATION
. If there have been no recent service actions, INSTALL a new FDIM to correct the failure to retain configuration data. REFER to FRONT DISPLAY INTERFACE MODULE (FDIM) . |
| U2051 | One or More Calibration Files Missing/Corrupt | CHECK vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI
procedures. If there have been recent service actions with this module, REPEAT/PERFORM the PMI
procedure as directed by the diagnostic scan tool. For more information, REFER to Programmable Module Installation (PMI) in MODULE CONFIGURATION
. If there have been no recent service actions, INSTALL a new FDIM to correct the failure to retain configuration data. REFER to FRONT DISPLAY INTERFACE MODULE (FDIM) . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
