2014 Ford Expedition Limited, 4WDFACTORY OEM SERVICE PROCEDURE

DTC Chart

NOTE: Some modules on this vehicle utilize a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous Memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
DTC Description Source Action
B2477 Module Configuration Failure
  • ABS module
  • Audio Front Control Module (ACM)
  • Audio Rear Control Unit (RCU)
  • Driver Seat Module (DSM)
  • Dual Climate Controlled Seat Module (DCSM)
  • Instrument Cluster (IC)
  • Restraints Control Module (RCM)
  • Satellite Digital Audio Receiver System (SDARS) module
  • Smart Junction Box (SJB)
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)  in this article.
B2477 Module Configuration Failure
  • Accessory Protocol Interface Module (APIM)
 CARRY OUT APIM  programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING  in this article.
B2477 Module Configuration Failure
  • PAM  - Navigator
 INSTALL a new PAM  . REFER to Parking Aid Module (PAM) .
B2477 Module Configuration Failure
  • Vehicle Dynamics Module (VDM)
 INSTALL a new VDM  . REFER to Vehicle Dynamics Module (VDM) .
B2900 Vehicle Identification Number (VIN) mismatch
  • ABS module
  • RCM 
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)  in this article.
P0602 Powertrain Control Module Programming Error
  • PCM
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)  in this article.
P0605 Internal Control Module Read Only Memory (ROM  ) Error
  • PCM
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)  in this article.
P1639 Vehicle ID Block Corrupted, Not Programmed
  • PCM
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)  in this article.
U0300 Internal Control Module Software Incompatibility
  • PCM
  • RCM 
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)  in this article.
U201A:51 Control Module Main Calibration Data: Missing Calibration
  • ACM 
  • Audio Digital Signal Processing (DSP) module
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)  in this article.
U2050 No Application Present
  • ABS module
  • ACM 
  • Audio RCU 
  • DCSM 
  • DSM 
  • IC 
  • PAM 
  • PCM
  • RCM 
  • SDARS  module
  • SJB 
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)  in this article.
U2050 No Application Present
  • 4X4 control module
 INSTALL a new 4X4 control module. REFER to 4X4 Control Module .
U2050 No Application Present
  • APIM 
 CARRY OUT APIM  programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING  in this article.
U2050 No Application Present
  • HVAC module
 INSTALL a new HVAC module. REFER to Heating Ventilation Air Conditioning (HVAC) Module .
U2050 No Application Present
  • Liftgate/Trunk Module (LTM)
 INSTALL a new LTM  . REFER to Liftgate/Trunk Module (LTM) .
U2050 No Application Present
  • Power Running Board (PRB) module
 INSTALL a new PRB  module. REFER to Power Running Board (PRB) Module .
U2050 No Application Present
  • VDM 
 INSTALL a new VDM  . REFER to Vehicle Dynamics Module (VDM) .
U2051 One or More Calibration Files Missing/Corrupt
  • ACM 
  • IC 
  • PCM
  • RCM 
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)  in this article.
U2051 One or More Calibration Files Missing/Corrupt
  • LTM 
 INSTALL a new LTM  . REFER to Liftgate/Trunk Module (LTM) .
U2051 One or More Calibration Files Missing/Corrupt
  • PAM  - Navigator
 INSTALL a new PAM  . REFER to Parking Aid Module (PAM) .
U2100:00 Initial Configuration Not Complete: No Sub Type Information
  • ACM 
  • Audio DSP  module
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI)  in this article.
U2100:00 Initial Configuration Not Complete: No Sub Type Information
  • APIM 
 CARRY OUT APIM  programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING  in this article.
U2101:00 Initial Configuration Incompatible: No Sub Type Information
  • APIM 
 CARRY OUT APIM  programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING  in this article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.