Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Ford Escape SFACTORY OEM SERVICE PROCEDURE
Network Message Chart
WARNING: This page is about a different car, the 2013 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
MODULE NETWORK INPUT MESSAGES - IPC
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Climate control status | HVAC module | This message contains the HVAC mode status for the mode indicators. |
MODULE NETWORK INPUT MESSAGES - PCM
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| A/C request (gateway) | HVAC module | This message requests the A/C compressor clutch to be engaged. |
MODULE NETWORK INPUT MESSAGES - HVAC MODULE
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Climate control requests (gateway) | BCM | This message contains all climate control system controls requests except blower motor speed. |
| Remote start status | BCM | This message contains the climate control system controls request for remote start. |
| A/C clutch status | PCM | This message contains the A/C compressor clutch status. |
| Ambient air temperature | PCM | This message contains raw value from the ambient air temperature sensor. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.