2014 Ford Edge Sport, FWDFACTORY OEM SERVICE PROCEDURE

Torque Specifications

Description Nm lb-ft lb-in
Ground wire nut (2.0L Gasoline Turbocharged Direct Injection (GTDI) 18 - 159
Starter motor bolt (3.5L & 3.7L) 48 35 -
Starter motor solenoid battery cable nut 12 - 106
Starter motor solenoid wire nut 5 - 44
Starter motor stud bolts (2.0L GTDI  ) 48 35 -
Starter motor stud bolt (3.5L & 3.7L) 48 35 -
Transmission manual control lever nut 18 - 159
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.