2014 Ford Edge Sport, AWDFACTORY OEM SERVICE PROCEDURE

External Controls

DTC DESCRIPTION

DTC Description Action
B1319:11 Brake shift interlock output circuit short to ground GO to PINPOINT TEST A .
B1319:15 Brake shift interlock output circuit short to power or open GO to PINPOINT TEST B .
P0815 Upshift switch concerns, open or shorted circuit For floor shifter, GO to PINPOINT TEST C . For paddle shifter, GO to PINPOINT TEST D .
P0816 Downshift switch concerns, open or shorted circuit For floor shifter, GO to PINPOINT TEST C . For paddle shifter, GO to PINPOINT TEST D .
P1780 TCS  circuit out of self-test range RUN the KOER  self-test. If DTC returns, GO to PINPOINT TEST E .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.