Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Ford Edge Sport, AWDFACTORY OEM SERVICE PROCEDURE
Body Control Module (BCM)
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B10DA:51 | PATS Target Identifier: Not Programmed | There is no PCM ID stored in the BCM . CARRY OUT a parameter reset. REFER to PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET . CLEAR the DTCs. REPEAT the self-test. |
| All other DTCs | - | REFER to the DIAGNOSTIC TROUBLE CODE (DTC) CHART . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.