Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Ford C-Max Energi SELFACTORY OEM SERVICE PROCEDURE
Air Conditioning Control Module (ACCM)
NOTE:
The ACCMÂ
is integral to the A/CÂ
electric compressor and cannot be serviced separately.
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| P0562:00 | System Voltage Low: No Sub Type Information |
|
| P0563:00 | System Voltage High: No Sub Type Information | |
| P0AFA:16 | Hybrid/EV Battery System Voltage Low: Circuit Voltage Below Threshold |
|
| P0AFB:17 | Hybrid/EV Battery System Voltage High: Circuit Voltage Above Threshold |
|
| P0AFB:1C | Hybrid/EV Battery System Voltage High: Circuit Voltage Out of Range |
|
| B11EE:19 | A/C Compressor: Circuit Current Above Threshold | GO to PINPOINT TEST I |
| B11EE:41 | A/C Compressor: General Checksum Failure |
|
| B11EE:4B | A/C Compressor: Over Temperature |
|
| B11EE:92 | A/C Compressor: Performance or Incorrect Operation | GO to PINPOINT TEST I |
| U0001:88 | High Speed CAN Communication Bus: Bus off | The module could not communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTCÂ . VERIFY the integrity of the connectors and wiring. |
| U0140:00 | Lost Communication with Body Control Module: No Sub Type Information | GO to PINPOINT TEST D |
| U0293:00 | Lost Communication with Hybrid/EV Powertrain Control Module: No Sub Type Information | GO to PINPOINT TEST U |
| U0422:00 | Invalid Data Received From Body Control Module: No Sub Type Information | RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the BCMÂ
. REFER to: BODY CONTROL MODULE (BCM) . |
| U3000:04 | Control Module: System Internal Failure | INSTALL a new A/CÂ
electric compressor. REFER to: AIR CONDITIONING (A/C) ELECTRIC COMPRESSOR . |
| U3000:42 | Control Module: General Memory Failure | CLEAR the Diagnostic Trouble Codes (DTCs). CYCLE ignition. OPERATE the system on MAX A/C for 5 minutes, then REPEAT the self-test. If the DTCÂ
returns, INSTALL a new A/CÂ
Electric Compressor. REFER to: AIR CONDITIONING (A/C) ELECTRIC COMPRESSOR . |
| U3000:49 | Control Module: Internal Electronic Failure | CLEAR the Diagnostic Trouble Codes (DTCs). CYCLE ignition. OPERATE the system on MAX A/C for 5 minutes, then REPEAT the self-test. If the DTCÂ
returns, INSTALL a new A/CÂ
Electric Compressor. REFER to: AIR CONDITIONING (A/C) ELECTRIC COMPRESSOR . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
