Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering Angle Sensor Module (SASM)
| DTC | Description | Action |
|---|---|---|
| C1B00:49 | Steering Angle Sensor: Internal Electrical Failure | CLEAR the DTCÂ
, CYCLE the ignition, CARRY OUT the SASMÂ
self-test. If the DTCÂ
returns, INSTALL a new SASMÂ
to correct the failure to retain software data. REFER to: STEERING ANGLE SENSOR MODULE (SASM) . |
| C1B00:61 | Steering Angle Sensor: Signal Calculation Failure |
|
| C1B00:62 | Steering Angle Sensor: Signal Compare Failure |
|
| C1B00:64 | Steering Angle Sensor: Signal Plausibility Failure | CLEAR the DTCÂ
. TEST DRIVE the vehicle and CARRY OUT at least 1 left turn and 1 right turn. CARRY OUT a SASMÂ
self-test. If the DTCÂ
returns, INSTALL a new SASMÂ
. REFER to: STEERING ANGLE SENSOR MODULE (SASM) . |
| C1B00:81 | Steering Angle Sensor: Invalid Serial Data Received |
|
| C1B00:85 | Steering Angle Sensor: Signal Above Allowable Range |
|
| C1B00:87 | Steering Angle Sensor: Missing Message | The SASMÂ sets this DTCÂ when the module transmits information on the HS-CANÂ but does not get a response from any other module. REFER to: COMMUNICATIONS NETWORK . |
| C1B00:92 | Steering Angle Sensor: Performance or Incorrect Operation | CLEAR the DTCÂ
. TEST DRIVE the vehicle and CARRY OUT at least 1 left turn and 1 right turn. CARRY OUT a SASMÂ
self-test. If the DTCÂ
returns, INSTALL a new SASMÂ
. REFER to: STEERING ANGLE SENSOR MODULE (SASM) . |
| C1B00:96 | Steering Angle Sensor: Component Internal Failure |
|
| U0001:88 | High Speed CAN Communication: Bus Off |
|
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to PINPOINT TEST D |
| U0300:00 | Internal Control Module Software Incompatibility: No Sub Type Information | CHECK vehicle service history for recent service actions related to the SASMÂ . This DTCÂ sets due to incomplete or improper flash programming procedures. If there have been recent service actions with the SASMÂ , REPEAT the programming procedure as directed by the diagnostic scan tool. |
| U3003:62 | Battery Voltage: Signal Compare Failure | GO to PINPOINT TEST L |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
