Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Ford Transit Connect XLFACTORY OEM SERVICE PROCEDURE
Engine Cooling System DTCS
PCM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| P0128:00 | Coolant Thermostat (Coolant Temp Below Thermostat Regulating Temperature): No Sub Type Information | GO to PINPOINT TEST C . |
| P0480:00 | Fan 1 Control Circuit: No Sub Type Information | REFER to the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) . |
| P0481:00 | Fan 2 Control Circuit: No Sub Type Information | REFER to the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) . |
| P1285:00 | Cylinder Head Overtemperature Condition: No Sub Type Information | GO to PINPOINT TEST B . |
| P1288:00 | Cylinder Head Temperature (CHT) Sensor Out of Self-Test Range: No Sub Type Information | GO to PINPOINT TEST B . |
| P1299:00 | Cylinder Head Overtemperature Protection Active: No Sub Type Information | GO to PINPOINT TEST B . |
| All Other PCM DTCs | - | REFER to ELECTRONIC ENGINE CONTROLS . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.